Last Updated on August 7, 2021 by Admin 3
DRAG DROP
Match the Dynamic Trunking Protocol (DTP) configuration on the switch ports so that a trunk link can be established. (Click and drag the DTP modes on the left and place them with their corresponding port on the right.)


Explanation:
There are five DTP modes:
– Trunk: Switch will establish trunk if other end port is configured as Trunk/Desirable/Auto.
– Dynamic Desirable: Switch will establish trunk if other end port is configured as Trunk/Desirable/Auto.
– Dynamic Auto: Switch will establish trunk if other end port is configured as Trunk/Desirable.
– Nonegotiate: Other end port should also be configured with Nonegotiate, or should be a device that does not support DTP.
– Access: No trunk establishment.
There are five DTP modes:
– Trunk: Switch will establish trunk if other end port is configured as Trunk/Desirable/Auto.
– Dynamic Desirable: Switch will establish trunk if other end port is configured as Trunk/Desirable/Auto.
– Dynamic Auto: Switch will establish trunk if other end port is configured as Trunk/Desirable.
– Nonegotiate: Other end port should also be configured with Nonegotiate, or should be a device that does not support DTP.
– Access: No trunk establishment.
Objective:
LAN Switching Fundamentals
Sub-Objective:
Configure and verify Layer 2 protocols