Which Cisco Internetwork Operating System (IOS) command produces this output?

Last Updated on August 7, 2021 by Admin 3

Refer to the following sample output:

200-301 Part 03 Q11 024
200-301 Part 03 Q11 024

Which Cisco Internetwork Operating System (IOS) command produces this output?

  • show interfaces
  • show interfaces summary
  • show interfaces serial fast-ethernet
  • show interfaces fast-ethernet 0/0
Explanation:
The show interfaces summary command will produce the given output. This command provides a summarized view of all interfaces configured on a device.

The show interfaces command is incorrect because this command does not produce the displayed output. This command is used to view information regarding statistics for specific interfaces. Without specifying an interface, a section for each interface will display, as in the example below for FastEthernet0:

200-301 Part 03 Q11 025
200-301 Part 03 Q11 025

The show interfaces serial fast-ethernet command is incorrect because this is not a valid Cisco IOS command.

The show interfaces fast-ethernet 0/0 command is incorrect. Although it produces similar output, that output only relates to the FastEthernet 0/0 interface. An example of this output follows:

200-301 Part 03 Q11 026
200-301 Part 03 Q11 026

Notice that the line of output that says FastEthernet0 is up, line protocol is up indicates that Layers 1 to 3 of the OSI Model are functioning correctly. Also, in the lower portion, there are no values in the error counters such as input errors, output errors, and so on. Finally, make note in line 8 where the interface is set to autosense both the duplex and the speed. Duplex and speed must be in agreement between the NIC on the host and the switch port.

Objective:
Routing Fundamentals
Sub-Objective:
Troubleshoot basic Layer 3 end-to-end connectivity issues

0 0 votes
Article Rating
Subscribe
Notify of
guest
0 Comments
Inline Feedbacks
View all comments