Which Cisco IOS command would produce the preceding menu-based prompt for additional information?

Last Updated on August 7, 2021 by Admin 3

Which Cisco IOS command would produce the preceding menu-based prompt for additional information?

200-301 Part 04 Q19 047
200-301 Part 04 Q19 047
  • tracert 10.10.10.1
  • traceroute 12.1.10.2
  • ping 10.10.10.1
  • ping
Explanation:
This menu-based prompt for additional information shown would be generated by the Cisco IOS ping command when issued without a target IP address. This is also known as issuing an extended ping. This command can be issued on the router to test connectivity between two remote routers. To execute an extended ping, enter the ping command from the privileged EXEC command line without specifying the target IP address. It takes the command into configuration mode, where various parameters, including the destination and target IP addresses, can be defined.

Note: You can only perform an extended ping at the privileged EXEC command line, while the normal ping works in both user EXEC mode and privileged EXEC mode.

The tracert command is incorrect because the tracert command is used by Microsoft Windows operating systems, not Cisco devices. This command cannot be run via the Cisco IOS command line interface. However, Microsoft’s tracert utility is similar to Cisco’s traceroute utility, which is to test the connectivity or “reachability” of a network device or host. The tracert command uses Internet Control Message Protocol (ICMP) to list all of the ‘hops” or routers traversed to a destination.

The traceroute command is incorrect because this command uses Internet Control Message Protocol (ICMP) to list all of the ‘hops” or routers traversed to a destination. It is also used to find routing loops or errors within a network.

The ping 10.10.10.1 command is incorrect because you when you issue this command you will either receive a reply from the destination or a destination unreachable message. It will not prompt for additional information as shown

Objective:
Routing Fundamentals
Sub-Objective:
Configure, verify, and troubleshoot IPv4 and IPv6 static routing

0 0 votes
Article Rating
Subscribe
Notify of
guest
0 Comments
Inline Feedbacks
View all comments