Which settings represent the proper BITs per second, data bits, and parity settings for a HyperTerminal session to the router?

Last Updated on August 7, 2021 by Admin 3

Which settings represent the proper BITs per second, data bits, and parity settings for a HyperTerminal session to the router?

  • 19200,8,none
  • 9600,8,none
  • 9600,8, even
  • 19200,8,even
Explanation:
When setting up a HyperTerminal session to either a router or a switch, the proper settings must be enabled or the connection will not work. The proper settings are 9600 bits per second, 8 data bits, and none in the parity box. The HyperTerminal application is provided on Windows operating systems up to Windows XP. The path to the tool is Start > Programs > Accessories > Communications > HyperTerminal. For later Windows operating systems, a HyperTerminal program must be downloaded and installed.

After opening the tool, you will name the connection and select a COM port if you want to use a port other than the default, which is the serial port to which the console cable is connected. You will then be presented with the following box:

200-301 Part 05 Q02 049
200-301 Part 05 Q02 049

The settings should reflect 9600 bits per second, 8 data bits, no parity, 1 stop bit, and no flow control, as illustrated in this graphic:

200-301 Part 05 Q02 050
200-301 Part 05 Q02 050

All other options include incorrect settings in at least one category.

Objective:
Infrastructure Management
Sub-Objective:
Configure and verify device management

0 0 votes
Article Rating
Subscribe
Notify of
guest
0 Comments
Inline Feedbacks
View all comments